Fluid Bed Epoxy Coating For Starting Motor Stator Magnetic Filed
Coil WIND-HDP
(1) Application:
Stator lamiantion resin Epoxy coating Motorcycle, E-Bike stator
powder coating,
Coil epoxy coating of Starting stator field coil
(2) Competitive Advantages:
1. This power coating machine heat stator or armature stack and put
them into fluid bed
2. This machine can handle big size coil stator or armature stack
lamination
3. The machine is easy to operate, can rotate and vibrate to get a
even coating surface
(3) Working Process:
1. Fix the stator (work piece) in the fixture, then put it inside
the inductorium
2. Power on the machine, then the induction heater automatically
begin working,
the heating time could be set, when set time is reach heater
automatically stop,
Normally the heater time is 10s
3. Fetch out the fixture,then dip both side in the power coating
station,
the stator is hot, and the fixture is in normal temperature and
won’t burn you
4. Dip the fixture in the power coating station both side,
the dipping time is depened on stator stack thickness and powder’s
character,
For example,normally one side is 3s, then the other side 2s
5. After dipping, disassemble the fixture clean the fixture using a
air gun to
remove the remain power when necessary
6. Collect and put the stators into oven( the machine didn’t have a
oven with it),
the oven temperature need reach to 180～200℃ (depended on powder’s
character), keep that temperature for more than 30 minutes
(4) Parameter:
| No | Name | Parameter and requirement |
| 1 | 40KW high frequency induction heater | With Φ120mm inductorium 1PC |
| 2 | Cooling tank | 1PC With size L1000×W1000×H1000mm |
| 3 | Cooling water pump | 0.37KW |
| 4 | Powder coating chamber | 1 Set |
| 5 | Powder recycle system | On back side of powder coating chamber 1pc |
