Automatic Armature Winder For Slotted Commutator No Hook Skew Rotor
WIND-ST-TD2B
Application:
Armature winder for no hook slotted type commutator armature,Vacuum
cleaners hammers power tool
Advantages:
1. No need to work with special designated slotting undercutting
machine
2. Slotted type armature save copper wire and reduce cost comparing
to hook type armature,
but winding slotted type armature can be a challenge,
WIND-ST-TD2B is the best winder for slotted type commutator in Chin
among winder manufacturers
4. 98% yield rate above assured based on the commutator quality is
good
Fully automatic winding machine filed Japan machine manufacturers
are the pioneer, the rising demand
for high quality products and low labor cost, operator only need to
ensure enough raw materials, and
replace them in time without workpiece or copper wire, so that
continuous production can be ensured.
The number of shaft is usually high, so as to achieve high efficiency
production. A machine with enough
automation can meet the requirements of an employee handle two or
three winding machines at the same
time.
Suggestion:
1. What is Wire size and Wire slot size(Length,width and depth)
data
Wire size 17AWG (1.15 mm), Slot: blade width 1.143, length=7.14 mm,
depth= 5.95 mm
In normal condition,the wire slot should have enough space for the
wire to stay inside
and Wind Automation think if the depth is bigger, the wire can
acquire more space to stay inside slot,
while depth is more, length is more too
2. Could you please check if the commutator was pressed
consistanctly each time at same location
according armature stack?
The push pin witness marks on the commutator are consistent, so
commutator slotting is even uniform
Armature commutator and stack position is very important for
indexing consistantly
Wire Gauge |
Usually 0.20~1.2mm, Max machine handled 1.35mm (about AWG16)
|
Commutator type |
Slotted type riser type not hook type commutator
|
Automatic or semi |
Automatic,operator only need to load and unload armature, other
actions such as
hooking, winding, indexing and cutting are carried out by winding
machine
automatically
|
The automatic winding machine WIND-ST-TD2B can handle your armature
Wire Gauge smaller than 1.35mm,
It can winding 1pc in about 2 minutues, you can get around
240pcs/8hours,
Please click below picture to view video
