Rounded Square Stator Needle Winding Machine For Brushless Stepping
Motor WIND-1-TSM
Application:
WIND-1-TSM is a basic needle winding mchine to be used in
laboratory for production of prototypes of
stators covering
6poles,8poles,9poles,10poles,12poles,14poles,18poles, such as
Stepping Motor,
Brushless DC Motor Muti Poles Stator
Advantages:
1. Easy to operate, very suitable for types of stators pilot run,
laboratory use
2. For some 8poles stator with dedicated winding diagram,
two needles can be applied to wind 2 slots per time
3. Change tooling and adjustment is simple,
Stator with 6poles, 8poles and 9 poles can use same winding machine
by changing tooling,
Stator with 10poles, 12poles, 14 poles can use same winding machine
by changing the tooling
4. Have a wide application of big and small, heave and light, thin
and thick wire brushless stators
Winder Techanical Specification:
| Wire diameter | 0.08~1.20mm |
| Turns No. | 0-99999 |
| Stator ID | 9~65mm |
| Stack height | 7-115mm |
| Stator Min Slot size | 1mm |
| Min. Needle Nozzle Size | 3*0.35*8.5mm |
| Operation Option | Stepping/Auto |
| Stator poles | 6 poles, 8 poles, 9 poles,10 poles,12 poles,14 pole,18 poles
(Customized) |
| Air pressure | 0.5~0.7MPa |
| Power | 1KW, AC220V 50/60Hz |
Productivity: Per stator opening of slot 1mm, suggest speed below
350RPM
Question and Answer:
1. Which type of stator needle winding shall we select for our
stator?
The machine WIND-1-TSM is widely used for 6 poles, 8 poles,9
pole,10 poles,12 poles,14 poles and
18 poles
Stepper motor and BLDC motor with Single phase or three phase
Machine Winding, Indexing and Cutting automatically without
arraying for slot filling rate not high stator
The winding machine WIND-1-TSM with winding not arrraying automatic
indexing device
and angle swing cam device is very suitable for winding big and small wire , heave or light BLDC
motor stators
2. How is the training to operate the stator winding machine?
For machine tranining, usually you send one engineer people to our
plant to inspect before delivery,
WIND-1-TSM is not a complicated machine, if your engineer have
experience then you don't need to
come and we can take some vidoes for you to operate
3. Is the machine from you is switched on and put into operation?
Yes, machine is switched on from machine side for power on machine
and
Start, Emergency button , Auto/Step swith to operate machine
4. I have not wound stator. Why do you need for wound stator?
The wound stator can show Shanghai Wind Automation
the winding diagram which include winding way,bridge wire, terminal
wire,
If you don't have wound stator, please provide winding drawing
Below samples and drawing are needed for machine manufacturing and
commissioning:
1. Stator stack 5pcs without winding with insulation cap or
isolation paper
2. Wound stator 1pc
3. Copper wire 1 roll enough for winding 10pcs stators
4. Stator lamination drawing and winding drawing
Please click below picture to view video
